CERAMAR® Flexible Foam Expansion Joint Filler is composed of a unique blend of isomeric polymers in a very small, closed-cell structure. Gray in color, CERAMAR is a lightweight, highly flexible and resilient material offering recovery qualities of over 99%. This mini closed-cell structure is virtually non-absorbent. It can be wrapped or formed around curved or circular surfaces.

The type of control joint and spacing used will vary with each project according to the type of structure, climatic conditions and anticipated stresses in the concrete. Thinner joints of 1/4” (6.35 mm), 3/8” (9.53 mm) or 1/2” (12.7 mm) spaced at frequent intervals offer greater control than thicker joints spaced at greater intervals. The basic objective is to provide ample room for the concrete to expand or contract without creating damaging stresses. Expansion joints should be positioned against forms at interrupting objects or columns and against abutting structures prior to the placement of the concrete. ASPHALT EXPANSION JOINT should be recessed 1/4” (6.35 mm) below the concrete surface. A sealant is not required. FIBRE, CERAMAR, SPONGE RUBBER, CORK and SELF- EXPANDING CORK EXPANSION JOINT should be recessed 1/2” (12.7 mm) below the concrete surface to accept the joint sealant. To isolate filler from sealant, use SNAP-CAP. (Refer to data sheet #324.)

SNAP-CAP should be installed flush with the surface. After removal of the top section of SNAP-CAP, the joint opening is ready for sealing with a suitable sealant from W. R. MEADOWS. NOTE: A joint sealer is not required for ASPHALT EXPANSION JOINT.

Suitable sealants for horizontal applications of CORK and SELF-EXPANDING CORK EXPANSION JOINT are #164, HI-SPEC, SOF-SEAL, GARDOX, DECK-O-SEAL® and SAFE-SEAL® 3405. GARDOX and DECK-O-SEAL are recommended for use with SPONGE RUBBER EXPANSION JOINT. The recommended sealant for vertical applications is DECK-O-SEAL GUN GRADE.